Shell units on the River Adur and Kingston Wharf
A shell unit's floor has usually been poured by one contractor and walked on by many others before the tenant arrives. By fit out, it may carry plaster splashes, paint, sealer overspray, ridges where bays meet and a weak, dusty top. Whatever goes on next, whether carpet tiles, vinyl or a coating applied by others, will only hold as well as the surface beneath it, so the contamination has to come off and the weak top with it.
Diamond grinding deals with all of that in one pass or a few. Diamond segments on a spinning head shave the surface down a fraction at a time, so lips between bays and trowel marks come down and contamination is removed. The exposed surface is then open and clean, which is what primers and adhesives need.
Where the specification calls for resin, polished concrete or a sealed decorative finish, that is a separate trade. We prepare the floor for the resin contractor and step away; those finishes are not something we lay.
Self-storage and office floors can be large, and the method should suit the area. For big, open halls or thick coatings, shot blasting is often the faster route, and our shot blasting and floor preparation covers it. Units that need a new wearing layer rather than preparation come under commercial floor screeding.
Extensions and refits in Shoreham-by-Sea houses
Homes produce smaller grinding jobs with the same aims. When a semi is extended at the back or opened up into a kitchen diner, the new floor and the original one seldom meet perfectly. A slight lip at the old back door shows under LVT, so grinding the higher side down is often the neatest fix before a thin compound brings both rooms to one plane.
New floors carry their own residue. Homes built since 2015 make up 6% of the town. Where a newer floor was laid in calcium sulphate screed, its laitance has to come off before flooring.
In a refit, lifting old vinyl or carpet tends to reveal adhesive, and sometimes paint along the skirting. Grinding takes it back to bare concrete.
Silica is the hazard throughout. Concrete and screed release respirable crystalline silica dust when cut, so every grinder we run is connected to extraction, and neighbouring rooms are sealed off. That care counts double in a flat where neighbours share the stairwell.
Grinding does not cure a floor that sags or falls across a whole room, and chasing a level by cutting deeper can leave the screed too thin. In that case the high spots are ground and the floor built back up with smoothing compound over the low areas.
How we price floor grinding in Shoreham-by-Sea
A fixed written price within 24 hours, once we know the area and what has to come off. See our floor screeding cost guide.
Who grinds your concrete floor in Shoreham-by-Sea
K & B Screeding’s own team, led by director Donatas Bardisevicius. Founded 2019, company 12298780.
See what customers say in our Google reviews and on our testimonials page.
Concrete Floor Grinding from Slough to Shoreham-by-Sea
On the map, Shoreham-by-Sea sits south-south-east of Slough, about 50.9 miles from our base in a straight line (postcodes including BN43 and BN15), next to Southwick (1.5 miles), Worthing (4.5 miles), Brighton and Hove (5.7 miles) and Burgess Hill (10.5 miles).
More on floor grinding, part of our screeding services.
