Grinding unit floors at Freebournes Park and Eastways
Diamond grinding uses rotating heads fitted with diamond segments that shave the top of the concrete or screed away a fraction at a time. If part of a unit at Freebournes Park or on the Eastways Industrial Estate becomes a counter, office or showroom, grinding is normally the first step.
Warehouse slabs pick up a lot over a working life. Painted walkway lines, a sealer that has worn patchy, glue from carpet tiles in an old office corner, and lips where two bays of concrete were finished at slightly different heights all have to go before a new finish is laid. Grinding removes them and opens up a clean, firm surface. What follows depends on the plan: a skim of compound, a new screed, tiles or LVT, or a resin system applied by a specialist firm. Resin and polished concrete are not something we lay, so the grind is prepared to whatever profile the next trade asks for.
There is a limit worth knowing. Grinding takes down local high spots and ridges, but it cannot correct a slab that falls away across the whole floor. In that case we grind the peaks and then build up the low side with compound or screed. Taking off too much is a risk on a screed as well, because grinding it below its minimum depth weakens it, so depths are checked before we start.
For big warehouse areas or thick coatings, shot blasting or scarifying can be quicker, and our shot blasting and floor preparation service covers those alternatives.
Old adhesive and extension joins in Witham homes
In homes, grinding is mostly about what earlier floors left behind. When old carpet, vinyl or cushion flooring comes up in Witham's overspill terraces, the concrete beneath is often coated in adhesive. Compound and new glues will not hold to it reliably, so it is ground back to bare concrete before anything else goes down.
Rear extensions raise a different issue. Where a new slab meets the old floor of the house, the two rarely finish at exactly the same height, and a ridge along the join will show through a thin finish. Grinding takes the lip off so the floor runs through. If a step remains after that, levelling the floor after grinding is the next stage.
Garages being turned into rooms follow a similar pattern: oil stains, paint and a rough surface come off first, and our garage conversion floor guide explains the screed that usually follows.
Dust is the reason to leave this work to a crew with the right equipment. Concrete, screed and tile all contain silica, and grinding them releases fine respirable crystalline silica dust that should not be breathed. We grind only with extraction connected and seal the room off from the rest of the house.
How we price floor grinding in Witham
A fixed written price within 24 hours, once we know the area and what has to come off. See our floor screeding cost guide.
Who grinds your concrete floor in Witham
K & B Screeding’s own team, led by director Donatas Bardisevicius. Founded 2019, company 12298780.
See what customers say in our Google reviews and on our testimonials page.
Concrete Floor Grinding from Slough to Witham
On the map, Witham sits east-north-east of Slough, about 58.3 miles from our base in a straight line (postcodes including CM8), next to Maldon (5 miles), Braintree (6.6 miles), Chelmsford (8.4 miles) and Halstead (10 miles).
More on floor grinding, part of our screeding services.
